The PVC garden hose HOBBY is a plain, reinforced water hose for water supply and irrigation around the garden. It comes in four bores and two coil lengths, and not every bore is stocked in every length. This guide covers what the hose is made of, which sizes you can order, how to choose a bore for a garden tap or a longer irrigation line, the one use it must not be put to, and how to look after it over winter.
What the HOBBY hose is made of
- Tube: PVC, black.
- Reinforcement: braided polyester.
- Cover: PVC, in yellow or green.
The product page also states the compound contains no cadmium and no barium. The stated application is water supply and irrigation only, and the page gives no pressure rating, so ask us before connecting it to a pump or pressure washer.
Bores and coil lengths you can order
HOBBY is offered in inner diameters of 12.5 mm, 15 mm, 19 mm and 25 mm, in coils of 20 m and 50 m; if you need a different length, ask us. The combinations listed on the page are:
- 12.5 mm: 20 m coil.
- 15 mm: 20 m or 50 m coil.
- 19 mm: 20 m or 50 m coil.
- 25 mm: 20 m coil.
Pick a pairing that is not on that list and the page tells you that combination is not stocked and invites you to ask about it. Each option has its own price on the product page, ex VAT, so check it there when you order.
If you need a 25 m coil, or 50 m in 25 mm, the alternative is the NTS Garden Hose, a multi-layer garden hose sold in 25 m and 50 m coils (not every bore comes in every length).
Choosing a bore for a garden tap or irrigation run
The bore is the inside diameter of the hose, and it decides both flow and which fittings will go in. If you are not sure what you have now, our guide on how to measure hose bore explains how to check it on an old hose or a fitting. As a general guide for any water hose:
- 12.5 mm is the smallest bore offered and the easiest to handle for beds, pots and a lawn close to the house; check that your connectors are made for that bore.
- 15 mm suits a longer run where you still want a hose that is easy to handle.
- 19 mm carries more water over a long length, so flow at the far end drops off less. It is heavier and needs fittings made for that bore.
- 25 mm is for moving a larger volume, such as filling a water butt for irrigation or feeding an irrigation header, rather than hand watering.
For length, measure the route the hose will actually take, from the tap round paths, beds and corners to the furthest point, and add some slack so it is never pulled tight at the tap. A 20 m coil covers most small and medium gardens. For an allotment or a long back garden, the 50 m coil in 15 mm or 19 mm is the one to look at, and the longer the run, the more the larger bore helps.
Match every connector to the bore. Where you use a barbed fitting, put a clamp on each joint sized to the outside diameter of the hose, measured on the hose itself. Route the hose without tight bends or kinks, and keep it off sharp edges such as paving, fence wire and metal edging.
Temperature range and the not-for-food warning
The page gives a working temperature of -15°C to +60°C. That covers normal garden water temperatures, but do not connect it to a hot water supply above that limit.
The page is also clear that HOBBY is not suitable for food products. Do not use it to transfer anything that will be eaten or used in preparing food. The page makes no drinking-water claim either, so do not treat it as a drinking-water hose for a caravan or a camping tank. If you need a hose for that kind of use, ask us before you buy.
Storing the hose over winter
The -15°C figure is a working limit, not a reason to leave the hose out all winter. Water left inside any hose can freeze and split it, and PVC stiffens in the cold, so a frozen hose that is bent or trodden on is more likely to crack.
- Disconnect it from the tap before the first frosts and drain it fully, lifting one end and walking the water out.
- Coil it loosely on a reel or in large loops, with no sharp fold.
- Store it in a shed or garage, out of direct sun and away from anything sharp or hot.
- In spring, check the hose and its ends for cracks or splits, and cut back a damaged end before refitting a connector.
How to order or ask
Choose the bore and coil length on the PVC garden hose HOBBY page and add it to the cart, or use the Order on WhatsApp button, which writes out the hose, size and quantity for you. Delivery is UK only and priced by length, and stocked lines ordered before 14:00 on a working day are packed the same day. If the combination you need is not listed, or you are unsure which bore suits your tap or fittings, call +44 (0) 7717 217388 and tell us the bore, the length of the run and what will go through the hose.


